What are the requirements for raw materials for CNC machining manufacturers to share the processing of large mechanical parts?

Before processing large-scale mechanical parts, we must pay attention to the density of raw materials. If the density is too large, it is equivalent to the hardness. If the hardness exceeds the hardness of lathe tool, it cannot be processed. It will only damage the parts, but also cause risks, such as the tool flying out hurting people. So, what are the requirements of large mechanical parts processing for raw materials?

The data of large-scale machining can be divided into two categories: metal data non-metal data. For metal data, the hardness of stainless steel is the largest, followed by cast iron, followed by copper, finally aluminum. The processing of ceramics plastics belongs to the processing of non-metallic materials.

Stainless steel materials used for machining large mechanical parts

1. First of all, the hardness of data is required. For some occasions, the higher the hardness is, the better the data is. It is only limited to the hardness requirements of machining parts. The processed data cannot be too hard. If it is harder than the parts, it cannot be machined.

2. Secondly, the raw material is of moderate hardness, at least one level lower than the hardness of the machine parts. Together, it depends on the function of the processed devices the reasonable selection of materials for the machine parts.

In a word, there are still some requirements for raw materials in large-scale machining, all raw materials are suitable for processing, such as too soft too hard data. The former is necessary for processing, while the latter is .